JackCubeLantern
4
Likes
103
Downloads
499
Views
Published on October 24, 2012
Description
it's a cubic Jack O'Lantern
the lid is just intended as a topper, not a tight fitting seal.
my intention is to use the small electric tealights inside. the light should make the eyes and mouth glow more brightly.
the lid is just intended as a topper, not a tight fitting seal.
my intention is to use the small electric tealights inside. the light should make the eyes and mouth glow more brightly.
Instructions
scale as desired
the lid has small dimples to accept the prongs
on the top of the main piece.
If you use a raft make sure to clear them.
My test settings
ABS
10% infill
1 shell
.27 slice
80mm/sec 230
printed ok, I did have to ream the holes a little to make the lid
fit properly.
I used a phillips screwdriver and just a turn or two was enough
to clear the holes.
the lid has small dimples to accept the prongs
on the top of the main piece.
If you use a raft make sure to clear them.
My test settings
ABS
10% infill
1 shell
.27 slice
80mm/sec 230
printed ok, I did have to ream the holes a little to make the lid
fit properly.
I used a phillips screwdriver and just a turn or two was enough
to clear the holes.
License
JackCubeLantern by cerberus333 is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from cerberus333
More from Containers
You must be logged in to post a comment.