clip-on mustache
29
Likes
433
Downloads
2193
Views
Published on October 24, 2012
Description
For the ladies (or the follicle-challenged)... Don't be left out of the next mustache-themed event.
See the full story at jmillerid.com/wordpress/2012/10/clip-on-mustaches-for-crushtoberfest-12/
See the full story at jmillerid.com/wordpress/2012/10/clip-on-mustaches-for-crushtoberfest-12/
Instructions
1. 3D print the two parts
2. glue them together with your adhesive of choice (I used Loctite 416, hot glue would work just as well)
3. Strike a surly mustache pose!
2. glue them together with your adhesive of choice (I used Loctite 416, hot glue would work just as well)
3. Strike a surly mustache pose!
You must be logged in to post a comment.
Looks awesome! Did you print with supports? If not, what's your secret for dealing with the overhangs?
ps- I've been out of the Makerbot loop for a while... I know there's dual extrusion now, but does it do supports?
yes, this was printed on a Dimension printer with soluble support, but I find the process of dissolving the support material to be such a pain in the neck that I try to design without undercuts anyway (overhang is ok, just no undercuts). In this case the parts broke away from the support material nicely.