Printed Fabric !
57
Likes
352
Downloads
5930
Views
Published on October 24, 2012
Derived from
Clutch
by PrettySmallThings
Description
Thing No 31234 is a great design but couldnt fit it on my reprap prusa 2.
Cut it down to a nice square sheet.
Im guessin you could print a lot of them and make a tshirt?
Cut it down to a nice square sheet.
Im guessin you could print a lot of them and make a tshirt?
Instructions
should fit easy on a normal Prusa I2 heated bed.
tip: if using PLA use water down PVA glue instead of kapton/PET tape. It will stick better and also when print is gone let the glass cool down then get some soapy water on that glass. Print will come away much much easier
tip: if using PLA use water down PVA glue instead of kapton/PET tape. It will stick better and also when print is gone let the glass cool down then get some soapy water on that glass. Print will come away much much easier
You must be logged in to post a comment.
License
Printed Fabric ! by Enlightx is licensed under the Attribution - Share Alike - Creative Commons license.
This should be marked as a derivative if it is based on Thing No 31234.
it should be listed yes and i did select this option in the settings to display as a derivative from the beginning.
dont know why its not showing