Weighted Holder For Electronic Cigarette, Wacom Stylus, or Sharpie
11
Likes
325
Downloads
1173
Views
Published on October 24, 2012
Description
Keep your electronic cigarette (made for joyetech ego-c, might fit others), Wacom stylus, or Sharpie close at hand with this weighted holder.
Print both halves, fill with something heavy, then snap it together and put it on your desk!
Inventor part file included!
Print both halves, fill with something heavy, then snap it together and put it on your desk!
Inventor part file included!
Instructions
1. Print both halves.
The top is printed upside-down to keep the mating surface looking fine. The bottom is printed normally.
2. Fill with lead shot, screws, or anything you can find lying around that is heavier than air, small enough to fit in the cavity, but not small enough to leak out (no liquids please!)
3. The two parts should snap together fairly easily.
The top is printed upside-down to keep the mating surface looking fine. The bottom is printed normally.
2. Fill with lead shot, screws, or anything you can find lying around that is heavier than air, small enough to fit in the cavity, but not small enough to leak out (no liquids please!)
3. The two parts should snap together fairly easily.
License
Weighted Holder For Electronic Cigarette, Wacom Stylus, or Sharpie by hellphish is licensed under the Attribution - Non-Commercial - Creative Commons license.
You must be logged in to post a comment.