Aluminum mendel led ring fan mount
3
Likes
158
Downloads
1388
Views
Published on October 25, 2012
Description
This is a derivative of thing:16164, my custom designed (heh, aren't all these things custom?) extruder assembly has the fan too close to the hotend to use the Prusa led mount. Shortened the arms to fit better.
Instructions
I printed at .3mm layer height, obviously infill is not really an issue here. Caution! Make sure you're running your fan or flic.kr/p/dnHQph can happen.
After you print, clip the ends to allow the LED ring to slide in. I've found that adding a little heat from a lighter allows you to "reseal" the jaws back together.
I used these halo led rings from ebay: bit.ly/TXYMix
After you print, clip the ends to allow the LED ring to slide in. I've found that adding a little heat from a lighter allows you to "reseal" the jaws back together.
I used these halo led rings from ebay: bit.ly/TXYMix
License
Aluminum mendel led ring fan mount by badger32d is licensed under the Attribution - Share Alike - Creative Commons license.
More from 3D Printer Accessories
You must be logged in to post a comment.