Sports Model Flying Saucer for dualstrusion
1
Likes
645
Downloads
1019
Views
Published on October 24, 2012
Description
Industrial production of two tone flying saucers was taking a while, due to the need to separately print the hull and the insert. Now, with an accelerated firmware, you can have the entire saucer ready to glue together and invade planets, in less than 4 hours.
This is the same model as the Two Tone Flying Saucer (http://www.thingiverse.com/thing:11996) but prepared for dualstrusion.
Also top half and bottom half are printed simultaneously (on a Replicator)
This is the same model as the Two Tone Flying Saucer (http://www.thingiverse.com/thing:11996) but prepared for dualstrusion.
Also top half and bottom half are printed simultaneously (on a Replicator)
Instructions
Merge the dual_hull and dual_insert STL files for dualstrusion. Load your filament for the hull and inserts into the appropriate extruders.
Print!
Glue together top and bottom half. Use bits of filament in the registration holes to keep everything lined up.
Print!
Glue together top and bottom half. Use bits of filament in the registration holes to keep everything lined up.
License
Sports Model Flying Saucer for dualstrusion by gpvillamil is licensed under the Attribution - Creative Commons license.
More from gpvillamil
More from Toys & Games
You must be logged in to post a comment.