Maxamillion (Black hole)
by cerberus333, published
Maxamillion from the Black hole
This was a model cyclone had asked
"If you are on a robot roll, It'd be awesome if you would try your hand at doing a Maximilian From The Black Hole. "
So being one who sometimes likes to take up a challenge, I made a quickie knockoff. It is far from accurate. I think it does convey the look and feel of the robot tho.
Printing will require full support for the maxamillion02.stl.
ok i did a split version for printing easier.(without support)
Split model printed ok
I used a raft, but i think it would be
better without one (flatter parting line and easier glue-up)