Madbot02
4
Likes
161
Downloads
482
Views
Published on October 25, 2012
Description
another robot with a bad attitude
Modeled using tinkercad
Modeled using tinkercad
Instructions
i used
0% infill
1 shells
.27 slice
80mm/sec
230 degrees
some gaps at those settings
use 10 infill to reduce the gaps
or post ABS/acetone goop fills if you prefer
to save on filament.
0% infill
1 shells
.27 slice
80mm/sec
230 degrees
some gaps at those settings
use 10 infill to reduce the gaps
or post ABS/acetone goop fills if you prefer
to save on filament.
License
Madbot02 by cerberus333 is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from cerberus333
More from Model Robots
You must be logged in to post a comment.