clip-on mustache
11
Likes
544
Downloads
1277
Views
Published on October 25, 2012
Derived from
clip-on mustache
by jmillerid
Description
"The Push Broom", an alternate style clip-on mustache based on my earlier design.
See the full story at jmillerid.com/wordpress/2012/10/clip-on-mustaches-for-crushtoberfest-12/
See the full story at jmillerid.com/wordpress/2012/10/clip-on-mustaches-for-crushtoberfest-12/
Instructions
1. 3D print the two parts
2. glue them together with your adhesive of choice (I used Loctite 416, hot glue would work just as well)
3. Strike a surly mustache pose!
2. glue them together with your adhesive of choice (I used Loctite 416, hot glue would work just as well)
3. Strike a surly mustache pose!
License
You must be logged in to post a comment.