Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Replicator1 Tool Holder
13
Likes
287
Downloads
1366
Views
Published on October 26, 2012
Description
A large tool-holding accessory that sits on the side of the Replicator. Positions for SD cards, hex wrenches (aka allen keys), scraper cards etc.
Instructions
This is a LARGE print - the raft actually went over the edge of my build platform for this one. Essentially this is thing:23520 by MangoT21, with the hex wrench holes from thing:31742 dropped in to replace some of the slots I didn't plan on using.
SketchUp design uploaded. Note that RepG took a very long time to slice this (over one hour), perhaps because I used a higher fill than I normally would.
SketchUp design uploaded. Note that RepG took a very long time to slice this (over one hour), perhaps because I used a higher fill than I normally would.
Collections
Replicator Upgrades
by tspoolst
Things to Make
by 3design
Replicator Upgrades - Tool / SD Card Holders
by garyacrowellsr
License
Replicator1 Tool Holder by gth is licensed under the Attribution - Share Alike - Creative Commons license.
More from gth
More from 3D Printer Accessories
You must be logged in to post a comment.