Deck Book Holder + Smaller Version
by jeffersonbenson, published
I like to play Magic: The Gathering, but I often find it hard to carry my decks around along with cards I want to trade or use outside of a deck. So I roughed out the idea to create a 3d printable deck holder to grip onto a standard 3 ring binder. This would then occupy the third (right-most) column of the card sheets that would be used to store extra cards.
I mainly eyeballed a lot of this project, but the dimensions of the interior of the box should hold up to 60 cards in tournament sleeves. If you print 3 there should be enough room to fit all of them on one binder.
I don't personally own a 3d printer, but I'm in the planning stages of a design based on the Rostock printers I've been seeing. However, since I haven't been able to test this myself, your mileage may vary when you print this.
I also plan to upload a version that is much shorter for those of you who don't use card sleeves all the time.
Designed with Tinkercad.
Again, I've not yet tested this myself, but I assume all is good and well.
This is my first thing uploaded to Thingiverse, so I hope the community will like it.
Liked ByView All
Give a Shout Out
Deck Book Holder + Smaller Version by jeffersonbenson is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure jeffersonbenson would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).