Display for wooden plates
4
Likes
132
Downloads
679
Views
Published on October 27, 2012
Description
I was cleaning the shelf where all the 3D-printed and lasercutted objects are being presented and I was getting annoyed about some engraved plates of wood that just wouldn't stand straight because of the glass bottomplate.
So I decided to design a simple display where I could place them in. I made it of 3mm plywood. The engraved plates are 3mm thick so I decided to make the notch 4mm thick. Then it would be possible for some other plates to be placed in there to. It al is made with the lasercuttingmachine and the different parts slide into each other.
So I decided to design a simple display where I could place them in. I made it of 3mm plywood. The engraved plates are 3mm thick so I decided to make the notch 4mm thick. Then it would be possible for some other plates to be placed in there to. It al is made with the lasercuttingmachine and the different parts slide into each other.
Instructions
The display is made of 4 parts, 2 unique parts, twice lasercutted in 3mm thick plywood. They are being connected to each other trough the 3mm thick notches. No glue is needed.
License
Display for wooden plates by FabLabMaastricht is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from FabLabMaastricht
More from Organization
You must be logged in to post a comment.