Printable Model Wings
40
Likes
451
Downloads
2731
Views
Published on October 27, 2012
Description
For flyin stuff
thicker cord section too.
scale to suit.
thicker cord section too.
scale to suit.
Instructions
These wings should not need any support.
They feature a rounded leading edge, and since the tangent at the bottom is 45 degrees at the bottom, and gets more vertical, it should not print with support (depending on your printer settings)
Also they include a root tang, for stickin into fuselage wingroot boxes, and stuff like that (IE a way to hold the wing on)
lightening(always a weird word) holes are used throughout.
Yea I was lightening like a Boss! :>)
They feature a rounded leading edge, and since the tangent at the bottom is 45 degrees at the bottom, and gets more vertical, it should not print with support (depending on your printer settings)
Also they include a root tang, for stickin into fuselage wingroot boxes, and stuff like that (IE a way to hold the wing on)
lightening(always a weird word) holes are used throughout.
Yea I was lightening like a Boss! :>)
You must be logged in to post a comment.
License
Printable Model Wings by JDCUBED is licensed under the Attribution - Share Alike - Creative Commons license.
More from JDCUBED
More from R/C Vehicles
Crazy retracting, I think my printer would explode ;)
What about thin vertical wall instead of holes?
What scale is this, I scale this 1000% to get about 8.5 cm wing?
should be about 10.5 inches long total, maybe its how your program is converting it. It prints fine on my UP. Ultimately there is no point to solid walls, thats why modern airplanes and helis have holes in their struts and stuff. because the material there is best used elsewhere.