Fan mounts for sjkelly's dual carriage
5
Likes
58
Downloads
925
Views
Published on October 27, 2012
Derived from
AO-100 Dual Material Setup
by sjkelly
Description
The excellent sjkelly's carriage has mounting holes for two 40mm fans pointed towards the nozzle with a 45° angle. I actually needed to point fans towards the Budaschnozzle heat sink because of problems when dual-printing with PLA. So I designed this L-bracket.
More information about my setup (kindly sponsored by LulzBot!) is available at devel.lulzbot.com/AO-100/hardware/dual/dual_color/
More information about my setup (kindly sponsored by LulzBot!) is available at devel.lulzbot.com/AO-100/hardware/dual/dual_color/
Instructions
Each one needs four M3x16mm screws, (optional) washer and nut.
You must be logged in to post a comment.
License
Fan mounts for sjkelly's dual carriage by Sound is licensed under the Attribution - Creative Commons license.
More from Sound
More from 3D Printer Accessories
Thanks! I uploaded some photos of it here:
http://devel.lulzbot.com/AO-10...