ORCA 0.43 PCB Cover
8
Likes
969
Downloads
1467
Views
Published on October 28, 2012
Description
First of all, many thanks to Camiel for this very good hardware, it is really amazing.
This is a cover for both, for the great GEN6Deluxe PCB and the Arduino with Ramps
1.4 shield. Therefore the design is flexible and the LCD with knob and SD Card, as you can buy for example at
reprapdiscount.com can even be mounted. Because I do not own an LCD, I take over mainly the
measurements and the great idea for the reset knob from Chri, find under
thingiverse.com/thing:28767.
This is a cover for both, for the great GEN6Deluxe PCB and the Arduino with Ramps
1.4 shield. Therefore the design is flexible and the LCD with knob and SD Card, as you can buy for example at
reprapdiscount.com can even be mounted. Because I do not own an LCD, I take over mainly the
measurements and the great idea for the reset knob from Chri, find under
thingiverse.com/thing:28767.
Instructions
Please have a look to the assembly manual. If you encounter warping problems, use the files with the "warp preventer" and fix the edges during the print with some clamps.
I have installed it and it works fine. I have silenced the fan with a resistor and the cooling is still good enough. You should try it out.
I have installed it and it works fine. I have silenced the fan with a resistor and the cooling is still good enough. You should try it out.
License
ORCA 0.43 PCB Cover by JackT is licensed under the Attribution - Share Alike - Creative Commons license.
More from JackT
More from 3D Printer Accessories
You must be logged in to post a comment.