Stand for Teenage Engineering OP-1 Synth
10
Likes
215
Downloads
3086
Views
Published on October 29, 2012
Description
Simple stand and screw set. It doesn't show from front Print print 2 of each for each side.
Fit recess on the either upper or lower rubber fit of OP-1 at your preference.
**********************************
DO NOT FORCE SCREW TO OVERLY SECURE THE STAND. IT WILL BREAK!! After all, it is plastic.
Fit recess on the either upper or lower rubber fit of OP-1 at your preference.
**********************************
DO NOT FORCE SCREW TO OVERLY SECURE THE STAND. IT WILL BREAK!! After all, it is plastic.
Instructions
Print stand with thick wall (1.5mm in my case) with 0% fill.
Print screw with 100% fill, and as the hot end reaches the top layer, you might want to speed up or slow down the process to prevent hot end melt and mangles the thread unusable.
Again, do not apply too much torque on the thumbscrew, as the head will break off from the stud.
Print screw with 100% fill, and as the hot end reaches the top layer, you might want to speed up or slow down the process to prevent hot end melt and mangles the thread unusable.
Again, do not apply too much torque on the thumbscrew, as the head will break off from the stud.
License
Stand for Teenage Engineering OP-1 Synth by MINIFACTURE is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from MINIFACTURE
You must be logged in to post a comment.