Fan holder 120mm Corsair AF120 for Prusa
4
Likes
123
Downloads
1558
Views
Published on October 29, 2012
Derived from
Parametric 120mm Fan Mounts
by binaryconstruct
Description
I like the design of binaryconstruct thingiverse.com/thing:26779 but the Corsair fans have a different (smaller) gap.
I have completely rebuilt the holder with Sketchup.
The fan has 63.47 CFM at 30dBA.
I have two of them running (one on each side) with this controller: thingiverse.com/thing:22202
I have completely rebuilt the holder with Sketchup.
The fan has 63.47 CFM at 30dBA.
I have two of them running (one on each side) with this controller: thingiverse.com/thing:22202
Instructions
Print two times.
You must be logged in to post a comment.
License
Fan holder 120mm Corsair AF120 for Prusa by capitaenz is licensed under the Attribution - Creative Commons license.
More from capitaenz
More from 3D Printer Parts
I've tried it.
Please explain how you did it.
1. Measure the width of the two rods
2. the center of the holes in the fan are about 104.5mm apart. So mock up that in something like blender, then take the thing, line it up to the 104.5mm things with the part that hooks into the fan.
3. modify the model to where the clip that hooks onto the bars go out that far(easy math req, something like distanceBetweenRods - 104.5/2, or something).
4. there is no step 4.