Bowden Extruder (Airtripper's) for pneufit
8
Likes
153
Downloads
1800
Views
Published on October 29, 2012
Derived from
Airtripper's Bowden Extruder
by Airtripper
Description
this is Airtripper's Bowden Extruder modified for an Pneufit
Instructions
this part is designed for an peneufit conection instead of the nut connection on the bowden cable.
it is based on Airtripper's design, but remodeled for: reprapworld.com/?products_details&products_id=168&cPath=1595_1616
in combination with a flat nut M10x4mm
i have not printed it yet because its a part for the printer i still am building.
it is based on Airtripper's design, but remodeled for: reprapworld.com/?products_details&products_id=168&cPath=1595_1616
in combination with a flat nut M10x4mm
i have not printed it yet because its a part for the printer i still am building.
You must be logged in to post a comment.
License
Bowden Extruder (Airtripper's) for pneufit by jasper2991 is licensed under the Attribution - Share Alike - Creative Commons license.
More from 3D Printer Extruders
Can I Modify my RepRap Prusa Mendal to take a Bowden Extruder setup. and still use my Motor and Hot end?
it actually is, you will have to adapt your hotend coupling to fit the cable coupling but it certainly is possible