African Mask wall hanging set!
34
Likes
919
Downloads
2384
Views
Published on October 31, 2012
This thing was Featured on November 1, 2012
Description
These masks were captured using Autodesk's 123d Catch software. I've flattened the bottoms and added a recessed screw catch in each for easy wall hanging.
Instructions
I printed both without support and it turned out fine. Mask1 has a weird overhang and resulted in a little spaghetti in one small area but I just cut it off with an exacto and all was well.
License
African Mask wall hanging set! by MikeBattaglia is licensed under the Attribution - Non-Commercial - Share Alike license.
More from MikeBattaglia
More from Scans & Replicas
Mask2 doesn't have a completely flat back so if you try to print it without support it might curl. I'm printing it with support right now so that probably won't be an issue for me.
Yeah, I noticed that there's one triangle that is slightly raised. I printed it without support and it came out fine but then again I was printing with PLA.
I'll upload an update soon.