Rostock Hotend Mount / Bowden Clamp
15
Likes
357
Downloads
1607
Views
Published on October 31, 2012
Derived from
Bowden Clamp with Zipties for Rostock
by EiNSTeiN_
Description
This is a hotend holder for Rostock printer with 4mm OD bowden tube clamp. It fits J-Head hotends (and other hotends with 16mm OD).
It uses M3 screws instead of M4 to mount to the platform.
It uses M3 screws instead of M4 to mount to the platform.
Instructions
Print without support material. There's a thin celling in the hotend hole that needs to be cut through to open the squeeze gap and bowden hole.
Use 2x M3x16 (or 20) bolts + nuts to secure the hotend and another 2x M3x20 bolts to mount to the platform.
You will need to point a small fan at the hotend body so that the heat from the hotend doesn't soften the mount.
Use 2x M3x16 (or 20) bolts + nuts to secure the hotend and another 2x M3x20 bolts to mount to the platform.
You will need to point a small fan at the hotend body so that the heat from the hotend doesn't soften the mount.
You must be logged in to post a comment.
Collections
3D Printer Extruder
by 11kmps
The Ultimate Rostock Printer Thing Collection
by EclecticAngler
Bowden Theory
by ibudmen
License
Rostock Hotend Mount / Bowden Clamp by piit79 is licensed under the Attribution - Share Alike - Creative Commons license.
More from piit79
More from 3D Printer Parts
I noticed this was posted a while back, how is it holding up?
Seems to be working well. Admittedly I haven't printed with my Rostock much as I still need to figure out some issues and I haven't had much time :(
I'm currently replacing the nut/zip tie clamp bowden attachment with pneumatic push in fittings. I will post the designs and link from here.