Carbon Filter Holder Box
4
Likes
202
Downloads
970
Views
Published on October 31, 2012
Description
Parts that make a filter box for carbon sheets.
Sheets which you can cut to size
Sheets which you can cut to size
Instructions
Cut carbon sheets to fit the holderbox.
Insert into the holderbox.
Place on inside of the printer cabinet.
Place 80mm fan into Fanholderbox.
Mount on outside of printer cabinet.
The fan holder was not print completly, nozzle ran into some loose support and I had to stop the print, but still good to be used.
I made this cabinet to fit a UP mini. The cabinet is from Zweden (you know, the same company were you can get the "billy" and "agneta")
The spool had to move to the side of the cabinet.
Have fun!!
Insert into the holderbox.
Place on inside of the printer cabinet.
Place 80mm fan into Fanholderbox.
Mount on outside of printer cabinet.
The fan holder was not print completly, nozzle ran into some loose support and I had to stop the print, but still good to be used.
I made this cabinet to fit a UP mini. The cabinet is from Zweden (you know, the same company were you can get the "billy" and "agneta")
The spool had to move to the side of the cabinet.
Have fun!!
You must be logged in to post a comment.
License
Carbon Filter Holder Box by Scubamatt41 is licensed under the Attribution - Share Alike - Creative Commons license.
More from Scubamatt41
More from 3D Printer Accessories
do you have pics of your cabines? where you buy your carbon filters? and does it help with the smell? i been looking into doing this.. thanks for your help
Hi mstyle183
You can see some other pics at:
http://pp3dp.com/forum/viewtop...
The cabinet is from Ikea
If you are looking to buy UP Plus or UP mini you will find lots of info in the PP3DP community forum.
The carbon sheet came from my local handyman store (DIY store).
It does help against the fumes!
The fumes gave my headache and uncomfortable feeling.
Now I can sit in the same room to design other stuff
Cheers