Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Linear Bearing Y Stage for Cupcake for Lowrider
12
Likes
77
Downloads
1188
Views
Published on October 31, 2012
Derived from
Linear Bearing Y Stage for Cupcake
by Zydac
Description
I just spread out the bearing mounts to fit the LowRider X-Carriage designed by TwoTimes
Instructions
Printed fine at 100% fill, no shells. Some overhangs, but should be ok.
11/1 - New version, the belt clamp need to be raised, and I lengthed the two bearing mount to better fit both bearings.
11/1 - New version, the belt clamp need to be raised, and I lengthed the two bearing mount to better fit both bearings.
You must be logged in to post a comment.
License
Linear Bearing Y Stage for Cupcake for Lowrider by slamzee is licensed under the Attribution - Creative Commons license.
More from slamzee
More from 3D Printer Parts
You got to it before I did!
Yes. But I just moved each mount out equally. I'm wondering I the one that holds the belt should be left where it was, or maybe I need to put a new clamp in.