Nema 17, 60mm fan side/edge mount.
2
Likes
77
Downloads
685
Views
Published on October 31, 2012
Description
My steppers run quite hot so i need to cool them down, but on the Y-axis there is not enough space for one of the rear mounted fans,
so i made this.
so i made this.
Instructions
This was very easy to print for my printer without supports
The part is quite sturdy so you can crank down the infill
Is mounted with a 3mm
The part is quite sturdy so you can crank down the infill
Is mounted with a 3mm
License
Nema 17, 60mm fan side/edge mount. by littleme02 is licensed under the Attribution - Share Alike - Creative Commons license.
More from 3D Printer Parts
You must be logged in to post a comment.