Ultimaker Weel Holder for small Holes V2
14
Likes
569
Downloads
1422
Views
Published on November 1, 2012
Description
Fabber Parts has some Filament Spools that dosn't fit to any of the currently published Spool Holders. So I decided to design my own...
Instructions
Print this with 100% Infill, 0.2mm Layerheight and 245°C on ABS. If Printing with CURA, use the INI-File "CURA-ABS Perfect.ini" for best Results. The "Dorn" needs a Raft to be printed.
Print 1x Endcap, 2x Clip and 1x Dorn
Time to Print each Part:
Endcap = 26 Min.
Clip = 28 Min. (x2)
Dorn = 165 Min.
Print 1x Endcap, 2x Clip and 1x Dorn
Time to Print each Part:
Endcap = 26 Min.
Clip = 28 Min. (x2)
Dorn = 165 Min.
You must be logged in to post a comment.
License
Ultimaker Weel Holder for small Holes V2 by dipicorg is licensed under the Attribution - Share Alike - Creative Commons license.
More from dipicorg
More from 3D Printer Accessories
-cylinder(h=LEN,r=14.5,$fn=FN);
+cylinder(h=LEN+25.0,r=14.5,$fn=FN);
Hello Tie-figther
Your suggestions have been applied... Thanx!!