Laser Tube Alignment Brackets
2
Likes
326
Downloads
981
Views
Published on November 1, 2012
Description
Laser tube alignment brackets for the Buildlog.net 2.x laser cutter. This version can be printed on a 3D printer with a 4" bed.
Instructions
If you are making a Buildlog.net 2.x laser cutter, you can use these two brackets to hold the laser tube in alignment. They have been modified from the original to fit on a 4" printer bed. The source is a combination of DXF and OpenSCAD.
You can adjust the printer size slightly using the parameters PW (printable width) and PB (printer bed). Both are sizes in millimeters. I made separate left and right brackets so the feet can stick out on opposite sides. It does not matter which bracket you use for which side.
2.x laser cutter: buildlog.net/blog/2011/02/buildlog-net-2-x-laser/
The original version of this part: buildlog.net/cnc_laser/erp/get_doc.php?docNumber=C17010
Attribution: The DXF file included was created by Bart Dring. The original is available from Buildlog.net.
You can adjust the printer size slightly using the parameters PW (printable width) and PB (printer bed). Both are sizes in millimeters. I made separate left and right brackets so the feet can stick out on opposite sides. It does not matter which bracket you use for which side.
2.x laser cutter: buildlog.net/blog/2011/02/buildlog-net-2-x-laser/
The original version of this part: buildlog.net/cnc_laser/erp/get_doc.php?docNumber=C17010
Attribution: The DXF file included was created by Bart Dring. The original is available from Buildlog.net.
License
Laser Tube Alignment Brackets by kbob is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.