Beefed Up Replicator Extruder Bracket w/Holes Normal Location
13
Likes
121
Downloads
1933
Views
Published on November 2, 2012
Description
MangoT21's Beefed Up Replicator Extruder Bracket is quite nice. On his Replicator 1, he found that he needed to move the filament guide holes backwards 0.1 inches; whereas, on my Replicator 1, I found that the original guide holes were correctly centered for my extruders. Consequently, the holes on MangoT21's bracket were a bit too far back for my Replicator 1.
This derivative is therefore MBI's original Wire-Filament Extruder Guide.SLDPRT model with the filament guide holes unmoved but reduced to a diameter of 9.5mm. Then the result exported from SolidWorks as an STL.
This derivative is therefore MBI's original Wire-Filament Extruder Guide.SLDPRT model with the filament guide holes unmoved but reduced to a diameter of 9.5mm. Then the result exported from SolidWorks as an STL.
Instructions
Instructions are as per Thing 26880. Please refer to its instructions at
thingiverse.com/thing:26880
thingiverse.com/thing:26880
License
Beefed Up Replicator Extruder Bracket w/Holes Normal Location by dnewman is licensed under the Attribution - Creative Commons license.
More from dnewman
More from 3D Printer Parts
I can't seem to find the one for a single extruder.
In the Replicator Thing here on Thingiverse, I do not see a SolidWorks file for a single extruder equivalent to "Wire-Filament Extruder Guide" which is the dual extruder bracket.
I didn't make one. You can look back at the original for which this is a derivative and see if MangoT21 made one.
If there isn't one but you have SolidWorks or anything which reads SolidWorks files, then you can pull the original for the Replicator and then just reduce the hole's diameter to 9.5mm.