Modular Air Flow Duct/Case
6
Likes
633
Downloads
1673
Views
Published on November 2, 2012
Description
I needed an air flow duct/case around the RAMPS board inside my MendelMax, but none of the existing things seemed to fit. Because there are so many of these cases, it seemed an interesting thought to make a modular version, so it becomes possible to make many kinds of ducts/cases with a single set of components. Attached STL's are for a 60mm fan and RAMPS 1.4 board and my setup. Note that I use a floorboard inside my MendelMax (see thing 28669), so the modules are designed to be screwed to a flat surface, rather than somehow connected to each other.
Instructions
No instructions provided.
You must be logged in to post a comment.
License
More from srepmub
More from 3D Printer Parts
I got a decent print out of it and this one will help me clean up the mess and hide a lot of these nasty wires. I use thing:28669 as well for raising my MM to provide more room under the printer.
great to hear, thanks for the feedback! I'd love to see a photo of your mendelmax when it's ready :-)