Free-standing Tool Holder
1
Likes
152
Downloads
882
Views
Published on November 3, 2012
Description
A tool holder with slots for SD cards, hex wrenches (aka allen keys), screwdrivers, pliers, side-cutters, scissors, pens, etc.
Although I keep post-it notes, a scalpel and digital verniers in it too, I wouldn't recommend doing so as their slots are not designed well and could do with improvements.
Derived from Replicator thing:23520 by MangoT21, except this one if free-standing. SketchUp design also uploaded.
Although I keep post-it notes, a scalpel and digital verniers in it too, I wouldn't recommend doing so as their slots are not designed well and could do with improvements.
Derived from Replicator thing:23520 by MangoT21, except this one if free-standing. SketchUp design also uploaded.
Instructions
NOTE! This is a LARGE print - the raft actually went over the edge of my build platform for this one.
Note that RepG took a very long time to slice this (over one hour), perhaps because I used a higher fill than I normally would.
The print itself was a LONG time on the Replicator (12-18 hrs) on the default RepG and 5.5 Firmware. I'd definitely encourage use of the Sailfish firmware instead, given the long dimensions involved you should see a massive improvement in print time.
Note that RepG took a very long time to slice this (over one hour), perhaps because I used a higher fill than I normally would.
The print itself was a LONG time on the Replicator (12-18 hrs) on the default RepG and 5.5 Firmware. I'd definitely encourage use of the Sailfish firmware instead, given the long dimensions involved you should see a massive improvement in print time.
You must be logged in to post a comment.
License
Free-standing Tool Holder by gth is licensed under the Attribution - Share Alike - Creative Commons license.
More from gth
More from 3D Printer Accessories
It sliced in 3 minutes 18 seconds on Slic3r... (30% honeycomb infill, 10 mm spaced support...)
Wow. Here's hoping that kind of improvement becomes mainstream.