Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Sarcophagus
12
Likes
80
Downloads
564
Views
Published on November 3, 2012
Description
sarcophagus
I liked the Coffin & Mummy
thingiverse.com/thing:32905
the coffin was nice , but more
suitable for a vampire or zombie.
So, here is a Sarcophagus for
mummy purists. or just use it to store what thou wilt.
Scale as desired, not sure how small it can go and still close etc.
my initial test print was 80mm long (3 1/4 inches) roughly, and the lid goes on nice and snug.
I liked the Coffin & Mummy
thingiverse.com/thing:32905
the coffin was nice , but more
suitable for a vampire or zombie.
So, here is a Sarcophagus for
mummy purists. or just use it to store what thou wilt.
Scale as desired, not sure how small it can go and still close etc.
my initial test print was 80mm long (3 1/4 inches) roughly, and the lid goes on nice and snug.
Instructions
this needs full support for the lid.
ran a small test print ok
running a biger print will post results when done.
I did some post printing touchup as the face was flat and
looked like a topographic map.
ran a small test print ok
running a biger print will post results when done.
I did some post printing touchup as the face was flat and
looked like a topographic map.
License
Sarcophagus by cerberus333 is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from cerberus333
More from Props
You must be logged in to post a comment.