Ultimaker mechanical Z endstop
2
Likes
148
Downloads
836
Views
Published on November 3, 2012
Derived from
Mechanical Z stop for Ultimaker
by owen
Description
My version doesn't block the slidingbock and is scaled to 53.75mm fitting the height we need
Instructions
Same instructions as in the original version of this thing:
"Make the height of this 1 to 2mm less than where your limit switch is set. The STL is 50.5mm from where it sits in the platform to the top. Scale the STL in Z to adjust for height. The underneath part won't change much with this scaling so don't worry about it. Alternatively you can adjust the Sketchup file and output a new STL."
"Make the height of this 1 to 2mm less than where your limit switch is set. The STL is 50.5mm from where it sits in the platform to the top. Scale the STL in Z to adjust for height. The underneath part won't change much with this scaling so don't worry about it. Alternatively you can adjust the Sketchup file and output a new STL."
License
Ultimaker mechanical Z endstop by gluetolf is licensed under the Attribution - Share Alike - Creative Commons license.
More from gluetolf
More from 3D Printer Accessories
You must be logged in to post a comment.