Raspberry Pi case with mem card shield
25
Likes
821
Downloads
3201
Views
Published on November 3, 2012
Derived from
Raspberry Pi case
by HansH
Description
A case for RaspberryPi. This is derivate of thingiverse.com/thing:16104 Developed together with Petteri Sillanpää. This was part of Devaamo - devaamo.fi - Hackday results.
Instructions
Contains Blender model of the bottom part. Top part STL file is from thingiverse.com/thing:16104. Both parts are collected here so it would be easier to find matching pairs. If using Cura, I found out that best fitting case is printed with Ultimaker when scale is set to "1.01". Developed together with Petteri Sillanpää. This was part of Devaamo Hackday results.
Top v3 modified: made power connection hole a bit bigger (my mod)
Bottom v3: fixed some errors in model and now it seems to be good enough (Petteri's mod)
To get ultimate fit, I had to carve some plastic off from top part. In top part I took some plastic away from the outermost poles (from the outer ring).
Top v3 modified: made power connection hole a bit bigger (my mod)
Bottom v3: fixed some errors in model and now it seems to be good enough (Petteri's mod)
To get ultimate fit, I had to carve some plastic off from top part. In top part I took some plastic away from the outermost poles (from the outer ring).
You must be logged in to post a comment.
License
Raspberry Pi case with mem card shield by kyyberi is licensed under the Attribution - Share Alike - Creative Commons license.
More from Electronics
Did the mods last night together with Petteri. Uploaded new models with pictures.