Green Man plaque
4
Likes
66
Downloads
502
Views
Published on November 4, 2012
Description
Green Man plaque
I will put some magnets on the back
and put it on my fridge.
Modeled in sculptris
I will put some magnets on the back
and put it on my fridge.
Modeled in sculptris
Instructions
I printed at
.27 slice
10% infill
80 mm/sec
230 degrees
the print is a little rough and will need a little post cleanup.
The z layers have that 'topographic map' look in some areas.
.27 slice
10% infill
80 mm/sec
230 degrees
the print is a little rough and will need a little post cleanup.
The z layers have that 'topographic map' look in some areas.
You must be logged in to post a comment.
License
Green Man plaque by cerberus333 is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from cerberus333
More from Decor
hum...
???