ShapeOko Terminal enclosure
9
Likes
198
Downloads
688
Views
Published on November 7, 2012
Description
This is an enclosure and lid for the terminal mounted on side of ShapeOko. It requires longer bolts than provided for the bare enclosure.
Instructions
Print with 25% fill and 3 shells .25mm layer height. The cover is meant to be held via friction so fits snuggly. It may require a little scaling based on the material you print with.
License
ShapeOko Terminal enclosure by BSchuler is licensed under the Attribution - Creative Commons license.
You must be logged in to post a comment.