Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
solidoodle hot end replacement plate
3
Likes
92
Downloads
758
Views
Published on November 7, 2012
Description
This part will allow you to replace the origional solidoodle hot end for the reprap mk4 hot end or any other with a 16mm PEEK.
Instructions
The hole is 16mm which will require some sanding for a tight fit. I have done this to make sure it was a tight fit to avoid any play in the parts. The design could probibly so with refining. One side has the corner cut, this must be facing the front right of the printer.
License
solidoodle hot end replacement plate by adamp is licensed under the Attribution - Share Alike - Creative Commons license.
More from 3D Printer Parts
You must be logged in to post a comment.