Z End Stop Extension for Solidoodle
2
Likes
77
Downloads
682
Views
Published on November 8, 2012
Description
Small piece that will fit onto your solidoodle's z end stop screw. It adds 3mm making it easy to put glass on your print bed.
Instructions
Print piece. Place on the screw and calibrate. Calibrating was a little tricky. It's easiest if you home the z axis without the glass on. then slide it under to see if it is close. Also once you are getting close move the build platform down 30mm each time you adjust so the extension piece is not being held in place by the build platform.
License
Z End Stop Extension for Solidoodle by JoeyE is licensed under the Attribution - Share Alike - Creative Commons license.
More from JoeyE
More from 3D Printer Accessories
You must be logged in to post a comment.