HTC EVO 4G LTE stand
Description
Instructions
You must be logged in to post a comment.
Looks great for a first attempt just a little confused here, doesn't the EVO LTE already have a kickstand? lol
it certainly does have a kickstand, which works better than the original evo's kickstand. one thing i notice on this design is that there doesn't appear to be enough room for the micro-usb plug. maybe dingo has a very short plug on his cable. my cables, however, i think have a minimum of 3/4 of an inch of unbendable plug that sticks out parallel with the flat side of the phone making this design unusable for me at least while plugged in.
one tip i'd offer for making this more 3d printer friendly is to round out the top of the square cut for the plug clearance as viewed from the rear of the stand. other than that i believe this should print without issue.
License
More from dingo
More from Mobile Phone
HI all,
Yes the new 4G LTE EVO does have a k-stand, however, the USB port is on the side of the phone where it rests on the table/surface.
My idea was to have a 90* USB wire placed inside , so it's always there, kind of like an OEM charging stand.
But this is not really sized properly and was just an exercise in uploading the files to thingV.
As soon as i have my PRINTRBOT clone dialed in and printing properly, I will work on this thing, and print one out.