Facet Chair Legs
4
Likes
106
Downloads
1167
Views
Published on November 11, 2012
Derived from
An Open Invitation to Design Join
by OpenDesign
Description
Machined out of oak, on a CNC. These chair legs were inspired by designer Phil Cuttance and his faceture project.
The legs use the 'An Open Invitation to Design' knuckle/join so they can be attached to any other object that uses the same system.
They are 450mm high and 25mm thick at the knuckle.
Cutting time was 4.5 hours with no hand finishing required.
See thingiverse.com/thing:34077 for the story behind these chair legs.
The legs use the 'An Open Invitation to Design' knuckle/join so they can be attached to any other object that uses the same system.
They are 450mm high and 25mm thick at the knuckle.
Cutting time was 4.5 hours with no hand finishing required.
See thingiverse.com/thing:34077 for the story behind these chair legs.
Instructions
No instructions provided.
License
Facet Chair Legs by OpenDesign is licensed under the Attribution - Share Alike - Creative Commons license.
More from OpenDesign
More from Household
You must be logged in to post a comment.