Planetarium
0
Likes
89
Downloads
504
Views
Published on November 9, 2012
Description
A Thing
Instructions
I printed it with full support, which left a lot to be desired in terms of a finished product. If you use the water-soluble plastic for the support, that would probably turn out better. It took about 2.5 hours to print, and another 5 minutes to carefully remove the support structure.
You must be logged in to post a comment.
License
Planetarium by BritKnight is licensed under the Attribution - Share Alike - Creative Commons license.
More from BritKnight
More from Sculptures
UPDATE: I edited the base. I made the gap a litlle large so that it's easier to remove the support material from inside the gap