Cat Toy with Base
Description
This is the cat toy but with a base, so no support is needed.
Instructions
Print. Sand off the base to have a round bottom (I use a bench mounted belt sander but a dremel or hand sander would work too).
You must be logged in to post a comment.
DarkAlchemist
on
November 9, 2012
said:
When making parts with other parts inside how do you get the inside part to print AND not be stuck to the other part? I can't figure this out for my own work.
apexio
on
November 9, 2012
said:
Good question. Trial and error is my preferred method. :)
However, if the overlap is one or two layers in print height and the overlap area is small compared to the size of the parts, it makes sense that it won't require much effort to separate the two parts.
In this case, I pry the inner ball loose with a flat head screwdriver.
License
Cat Toy with Base by apexio is licensed under the Attribution - Share Alike - Creative Commons license.
I like the size it's huge printing one now