Hanging mount for Ultimaker heatbed fan
1
Likes
114
Downloads
676
Views
Published on November 10, 2012
Description
I'm using a 120mm fan to cool down the heated bed after printing. This suspension holds the fan in an optimal position.
Instructions
1. Print two pieces.
2. Atttach to a 120mm fan.
3. Hang on the Ultimaker's side after printing is finished to accelerate cooldown.
2. Atttach to a 120mm fan.
3. Hang on the Ultimaker's side after printing is finished to accelerate cooldown.
License
Hanging mount for Ultimaker heatbed fan by hreese is licensed under the Attribution - Creative Commons license.
More from hreese
More from 3D Printer Accessories
You must be logged in to post a comment.