Replicator Fan Guard
by WillandMrData2, published
Recent Commentsview all
Hi, there is a two mil gap between fan and guard.
Feel free to change it how you like.
bye for now and be wellÂ :)Â :]
I like the decorative fan guards, but I've found that they restrict airflow and they can be noisy.
Have you considered building them to stand off of the fan a bit to allow airflow in from between the guard and the fan inlet?
Yeah i was very tight with the air intakes on that first one,,as mentioned its been widened a smidgen.
Yeah the logo and overall look is ok,,those grills ,,,either grates that are evenly spaced right accross so it don't clash with the top and bottom of the M ,,,,,,or grills that tapper off at the top and bottom so as to give the elusion of a curve which would make the M pop perhaps mores so but either design is cool.
I've tryed to go for the tapper off grills,,,they are almost right.
Some were didn't fill ,,,i do wonder about makeing them all not fill. hum.
Bye for now and be wellÂ :)Â :]
Liked Byview all
Give a Shout Out
Protecting fragile fan from espesially allen key when undoing lower bolts on fan. :)
Strongly suggest a fan cover, this or another or your own."must"~
Did i mention you should put a cover over fragile fan and get your self a fan cover.
below is film of this fan cover.
Download the stl to have or modify...
default settings, hbp 118* abs 20% infil.
Ok intake grill has been made a bit wider and M logo improved,,photo shows new fan guard on right. ",its getting there."
Bye for now and be well from Will and Mr Data :) :]
You must be logged in to post a comment.