Orca 0.43 v10b 3mm extruder parts
by Aggresive, published
This is modified to move the drive gear 0.6mm further away from the filament path than the original.
This should allow a much straighter filament path, similar to 1.75mm setup. The original caused the filament to bow around the drive gear.
The best solution would be to make the mounting bolts slots, so that the distance can be changed for the hot-end in use.
UPDATE: I've added a hole for a 3mm allen key, for easier large gear removal, and increased the depth of the inlet on the top piece.
Liked Byview all
Give a Shout Out
Print, drill/clean, fit as normal.