Loading
Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!

TASSIMO BIN

by sellemann, published

TASSIMO BIN by sellemann Nov 13, 2012

Description

Recycle Your tassimo capsules
This is a container for your used tassimo capsules. I figured out that instead og colecting them sending them for reused elseware, it was smarter to clean them chop them up and extrude them my self. This bin is for storing them until reextrution.

Recent Comments

view all
You ever think of designing a refillable coffee pod that fits in the tassimo? To me, the only thing needed to be able to refil these things are a lid with the two holes in the right locations and 3 gaskets (one on the outer rim, and one for the input water, and one for the output water), and a good clamp so the lid doesn't leak. Heck - you could even possibly just print a lid ONLY that fit on existing pods. I have looked everywhere and can't find such a thing, you would be the first to make it. Heck I would buy it if it was on Shapeways!
What are you using to re-extrude to usable filament?

More from Kitchen & Dining

view more

Liked By

view all

Tags

License

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Print recycle pin
collect tassimo
Send them to support rainforest alliance OR
Rinse
Chup
Extrud into something like another tassimo bin.

Note: When reusing plastic like this you might encounter that it can't conect to the previous layer.
If you reuse it several times it gets worse. SÃ¥ always mix new capsules with old former reused to keep your prints awesome.

NEWS:Added A lid to keep the Keep it nice.

The Lady is made out of tassimo ;-) Weird !!!! Maby i should offer her a cup of coffe.

The re extrution are made with a engel industrial glue gun witch normal use glue in bloks. In goes the clean screded t pods out comes 1.75 +-0.05 mm filement ;-) Workes with anything that melts between 150-280 degrees C

NEWS 23 Nov. 2012... The ideer just went to the final in the terra cycle contest. see the finalist here terracycle.dk/da/stemmeside
You ever think of designing a refillable coffee pod that fits in the tassimo? To me, the only thing needed to be able to refil these things are a lid with the two holes in the right locations and 3 gaskets (one on the outer rim, and one for the input water, and one for the output water), and a good clamp so the lid doesn't leak. Heck - you could even possibly just print a lid ONLY that fit on existing pods. I have looked everywhere and can't find such a thing, you would be the first to make it. Heck I would buy it if it was on Shapeways!
What are you using to re-extrude to usable filament?
Top