Scorpion
54
Likes
1592
Downloads
3659
Views
Published on November 13, 2012
Description
This is a scorpion puzzle. It was originally designed for a laser cutter. I extruded it in Openscad. I did not design this scorpion just made it 3D printable. This puzzle and many others can be found at blechwelt.com/teil_des_monats/archiv.htm
Instructions
The original scorpion is large. I wanted a small one that was more life size so I resized it. That is the one shown in the photo. Print one of the Part 1 plate and one of the Part 2 plate. I haven't printed the large version but, it should be about 150mm long. The small version is about 80mm long.
You must be logged in to post a comment.
eshoveler
on
November 16, 2012
said:
I just printed your scorpion and it worked beautifully! Thanks for sharing!!!
hindessm
on
November 14, 2012
said:
I made one of these a while back. I used a different source and didn't upload it as I had to file every part to make it fit. I'm very keen to try this one to see if it fits any better and will probably check out some of the other dxf files too. Thanks.
License
Hey Mate,
Sorry to post here, but there doesn't seem to be any other messaging service on this site, anyway, just wanted to let you know that I've posted the 10x4.7 props up.
Cool scorpion by the way. :)