T-slot x ends, compatible with Trinity Labs 4 Hole 2 Mount Delrin Nut Leadscrews
3
Likes
125
Downloads
747
Views
Published on November 14, 2012
Description
These are Designed to take the Trinity Labs 4 Hole Delrin Nut Leadscrews that use 2 holes for mounting
These x-ends use SA bushings (same OD for 8 or 10mm rods)
These x-ends don't hold x-rods, they hold a single 20x20 extrusion.
both ends have an integrated bolt holder meant to interface with a z-endstop held in the lower part from thingiverse.com/thing:28425
By the way these are intended to use a pair of 605zz bearings for the idler. You'll have to enlarge the hole either before or after printing if you intend to use 608zzs.
These x-ends use SA bushings (same OD for 8 or 10mm rods)
These x-ends don't hold x-rods, they hold a single 20x20 extrusion.
both ends have an integrated bolt holder meant to interface with a z-endstop held in the lower part from thingiverse.com/thing:28425
By the way these are intended to use a pair of 605zz bearings for the idler. You'll have to enlarge the hole either before or after printing if you intend to use 608zzs.
Instructions
No instructions provided.
License
T-slot x ends, compatible with Trinity Labs 4 Hole 2 Mount Delrin Nut Leadscrews by Hewball is licensed under the Attribution - Share Alike - Creative Commons license.
More from Hewball
More from 3D Printer Parts
You must be logged in to post a comment.