iPhone 5 Rounded Snap-On Case With Buttons
24
Likes
378
Downloads
4404
Views
Published on November 15, 2012
Derived from
Slim iPhone 5 Snap-On Case (tested)
by Helmi74
Description
Simple Snap on Iphone case that has Power and Volume buttons reproduced on the edges of the case. Front and back edges are rounded for a comfortable grip. Simple and secure fit. (Has been tested)
Instructions
While not a direct derivative, I liked the case Helmi74 created and I wanted to add a few features. I recreated the case from scratch and added buttons on the outside. Also the front and back edges are rounded, which I think makes it a bit more comfortable to hold.
After printing, take a fine hobby knife and clear out any threads that my interfere with the button clearance. Rub some sandpaper around any sharp edges, and give it a good cleaning to remove dust and debris.
Pop in your Iphone 5 and enjoy!
After printing, take a fine hobby knife and clear out any threads that my interfere with the button clearance. Rub some sandpaper around any sharp edges, and give it a good cleaning to remove dust and debris.
Pop in your Iphone 5 and enjoy!
You must be logged in to post a comment.
License
iPhone 5 Rounded Snap-On Case With Buttons by BrandonW6 is licensed under the Attribution - Share Alike - Creative Commons license.
More from BrandonW6
More from Mobile Phone
This looks awesome! Does it fit better than that "customizable" one that everyone seems to post?
It does for really well. However this was an earlier design I made. The buttons work ok but get in the way of the "silent mode" switch a little bit. I would suggest you check out the one from my IPhone cradle arm. It has a more secure lip all the way around. It's what's on my iPhone right now. Plus if you so want the cradle. It snaps right in.