Desk Dock for Razr Maxx HD
2
Likes
246
Downloads
1604
Views
Published on November 16, 2012
Description
This is a USB desk dock for the Razr Maxx HD.
The picture shows this dock, a similar dock for the Droid 2 (inspiration), and a partial-prototype.
Blog post w/ additional pictures at: genericmaker.com/2012/11/working-on-droid-razr-hd-maxx-case.html
The picture shows this dock, a similar dock for the Droid 2 (inspiration), and a partial-prototype.
Blog post w/ additional pictures at: genericmaker.com/2012/11/working-on-droid-razr-hd-maxx-case.html
Instructions
Cut down a USB cable so the plug will be long enough to reach through the plastic and make proper contact with the phone's jack. If present, you may file off the little clips that hold the USB connector in place so the phone can be removed easily.
There are cavities to accomidate up to three metal rods for additional weight. Maximum length is 130mm, maximum diameter is 6.35mm. These must be added mid-print.
There are cavities to accomidate up to three metal rods for additional weight. Maximum length is 130mm, maximum diameter is 6.35mm. These must be added mid-print.
You must be logged in to post a comment.
License
Desk Dock for Razr Maxx HD by GeorgeH is licensed under the Attribution - Non-Commercial - Share Alike license.
More from GeorgeH
More from Mobile Phone
Still working to duplicate the Motorola dock cable. I think it has a microprocessor in the cable to perform authentication.