Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Prusa rail kit
12
Likes
418
Downloads
992
Views
Published on November 16, 2012
Description
This kit allows the use of a rail for the Y-axis on a Prusa.
Instructions
Print (2 of the clamps if you are doing individual prints, the last STL is a full set, the previous are individual parts)
Assemble
You'll need 10 m3s 10 to 16mm ea (4 for the motor, two for each clamp and two for the belt tie down)
2 m3 nuts
m3 washers as you wish.
One m5 20mm+ and washers for the idler
two 605zz bearings for the idler.
A Rail with carriage store.trinitylabs.com/linear-rail-and-car-for-y-axis/
If you decide to go with 608zz bearings for your idler instead, you'll want to bore the idler mount hole out a bit either before or after printing.
Assemble
You'll need 10 m3s 10 to 16mm ea (4 for the motor, two for each clamp and two for the belt tie down)
2 m3 nuts
m3 washers as you wish.
One m5 20mm+ and washers for the idler
two 605zz bearings for the idler.
A Rail with carriage store.trinitylabs.com/linear-rail-and-car-for-y-axis/
If you decide to go with 608zz bearings for your idler instead, you'll want to bore the idler mount hole out a bit either before or after printing.
License
Prusa rail kit by TrinityLabs is licensed under the Attribution - Share Alike - Creative Commons license.
More from TrinityLabs
More from 3D Printer Parts
Could you upload a video of a finished prusa mod?