Ultimaker front low profile external Fan Mount
8
Likes
96
Downloads
1149
Views
Published on November 24, 2012
Description
I needed to mount my fan on the front of the head, because i was running out of room.
added some extra support to the screw shafts, because i managed to break 3 prints while installing this.
i use this with Gijs fanduct:
thingiverse.com/thing:21182
added some extra support to the screw shafts, because i managed to break 3 prints while installing this.
i use this with Gijs fanduct:
thingiverse.com/thing:21182
Instructions
cura 12.10.
30% infill
exterior only support
.8 wall,top/bottom
30% infill
exterior only support
.8 wall,top/bottom
You must be logged in to post a comment.
License
Ultimaker front low profile external Fan Mount by kwatts is licensed under the Attribution - Share Alike - Creative Commons license.
More from kwatts
More from 3D Printer Accessories
I like the web section joining the arms. I'll have to make a derivative-derivative. :)