Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
SH Sanlianhuan Ledao helimx 8828 part 016 Landing Skid
3
Likes
114
Downloads
1073
Views
Published on November 19, 2012
Description
SH Sanlianhuan Ledao HeliMX 8828 Landing Skid
RC helicopter part
This spare is for the following SH helicopters:
8828 Eagle Power Heli MX
8828-1 Eagle Power Heli MX Gyro
It will also fit:
8827 X8 Pro Exceed
8827-1 X8 Pro Pioneer MX Gyro
RC helicopter part
This spare is for the following SH helicopters:
8828 Eagle Power Heli MX
8828-1 Eagle Power Heli MX Gyro
It will also fit:
8827 X8 Pro Exceed
8827-1 X8 Pro Pioneer MX Gyro
Instructions
My first 3d print model, printed out fine.
Thing-o-matic print time per piece:
Normal: 1h 07min (estimated)
Accelerated: 31-32min (true)
It is a little more narrow than the original, because I had access to a Thing-o-matic that had only 100x100mm max printing surface.
Lenght: 93,63mm
Width: 44,40mm
Height: 16,00mm
Volume: 5,91cm2
Holes need to be drilled to exact size after printing.
NOTE:
I had to drill the holes that fix the "landing skid" to the helicopter a little bit oval just to increase the spacing(about 1mm wider) of the mounting holes to achieve a perfect fit.
(It could have been just a scale calibration problem)
This is a pretty straight forward deal what we got here:
-print
-clean up
-drill 4 holes for the screws (use 1mm for the lower, 3mm for the upper screws)
-drill/enlarge the metal rod mounting holes to 5mm diameter
Thing-o-matic print time per piece:
Normal: 1h 07min (estimated)
Accelerated: 31-32min (true)
It is a little more narrow than the original, because I had access to a Thing-o-matic that had only 100x100mm max printing surface.
Lenght: 93,63mm
Width: 44,40mm
Height: 16,00mm
Volume: 5,91cm2
Holes need to be drilled to exact size after printing.
NOTE:
I had to drill the holes that fix the "landing skid" to the helicopter a little bit oval just to increase the spacing(about 1mm wider) of the mounting holes to achieve a perfect fit.
(It could have been just a scale calibration problem)
This is a pretty straight forward deal what we got here:
-clean up
-drill 4 holes for the screws (use 1mm for the lower, 3mm for the upper screws)
-drill/enlarge the metal rod mounting holes to 5mm diameter
License
SH Sanlianhuan Ledao helimx 8828 part 016 Landing Skid by wictro is licensed under the Attribution - Share Alike - Creative Commons license.
More from wictro
More from R/C Vehicles
You must be logged in to post a comment.